So upload a the Maple mini blink sketch from examples\Digital\Blink and the Maple serial device should now be available on the Port menu. Note: If you do not see a Maple Serial com device, this is probably because the Maple mini has not been loaded with the blink sketch. Re-start the Arduino IDE, and select the appropriate board from the "Tools" -> "Board menu", and select the appropriate Com port for your Maple mini or serial upload device. In this video, we are going to see how to install the ST-Link Utility which includes also the driver for all the STM32 Development Boards.This video is part. The batch file and wdi-simple.exe do the clever stuff to convince Windows 7 or newer, that it should use its drivers with the Maple serial and DFU devices. However the built in drivers need to be associated with the USB ID of the Maple serial and DFU devices. Windows comes pre-installed with a compatible Serial USB driver and a DFU (upload) driver. Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft.
Kaouthar To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question. It is primarily intended to software developers or system administrators who are about to install the STM32CubeIDE product. Note: This doesn't actually install drivers. So, if you use a Windows® operating systems: 98SE, 2000, XP, Vista®, 7, and 8.x try to uninstall the driver and reinstall the last version. This installation guide for STM32CubeIDE gives directions on how to install software on each of the operating systems it supports. Please open a cmd window (run as administrator), navigate to the folder: /drivers/win/ and run: install_drivers.bat. If using Maple or Maple mini, you need to install drivers for the Serial and DFU (upload devices). This will enable developers on both Windows Surface X as well as Apple M1 + VM to work with STLink devices.Copy the Arduino_STM32 folder to My Documents/Arduino/hardware (Note: if the hardware folder doesn't exist you will need to create it). HID® EikonTouch TC510 Fingerprint Reader. This driver allows the reader to be used with Windows Hello. I simply renamed the amd64 folder to arm64 from the official driver and changed the content of the INF files as pointed out by GHARBI it would be great if ST re-releases ST Link so that it works on Windows 10/11 ARM64 with properly signed drivers (the CAT files must be updated). This is the WBF driver for the EikonTouch family of single fingerprint scanners including modules and readers.
Make sure that what you've downloaded contains only INF changes from the official drivers (I have not changed any binary files, which in this case are the official COM installers supplied and still properly signed by Microsoft. Important! This will install an unsigned driver. After rebooting with driver signature checks, go to Device Manager, find the STLink device and manually specify the folder where you've unzipped the file attached below.
To install, you need to temporarily disable driver checks: (use the temporary solution 3 - Reset while holding Shift).
To make that work, I have removed all references to the certificate signatures (CAT files) from INF files. I was able to make this work end to end with STM32CubeProgrammer and IAR on Windows 11 ARM64 (running in Parallels on an Apple M1).